Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Studio City?
Duct repair and sealing in Studio City typically costs $350 to $1,200 for most single-family homes, with small targeted repairs landing near the low end and full-house sealing projects running higher. A single leaky joint or disconnected run often falls between $180 and $450, while sealing the entire supply and return system usually runs $700 to $1,500 depending on how many runs are accessible and how much attic or crawlspace work is involved. We give a written estimate before any work starts, and that estimate sets the final price.
The range is wide because no two Studio City houses have the same duct layout. The flat-roof ranches and post-war bungalows on the south side of Ventura Boulevard often hide duct runs in tight soffits or low attics, while the hillside homes north of the boulevard frequently run ductwork through unconditioned attics that reach high temperatures in summer. Both conditions change the labor and the materials. If you’ve noticed one room that never cools, dust that settles faster than it should, or a musty smell when the system kicks on, a leaking duct is a common culprit. Call (855) 658-5111 for a free estimate, and we’ll tell you what the job looks like before you commit to anything.
Key Takeaways
- Typical duct repair and sealing in Studio City runs $350 to $1,200, with whole-system sealing at $700 to $1,500.
- A single run repair or reconnection is usually $180 to $450.
- Mastic sealing of accessible joints is the standard fix; duct tape is not.
- Access, attic heat, and the number of runs drive most of the price difference.
- We use Rotobrush and Nikro equipment to clean the system before sealing, so the surface is clean enough for sealant to bond.
Duct Repair & Sealing Cost Breakdown (2026)
Below are the typical estimated ranges for each part of a duct repair and sealing job in the Studio City market. These are estimates, not fixed prices, and the written estimate always sets the final figure.
| Service | Typical Estimated Range | What It Covers |
|---|---|---|
| Single joint or run repair | $180 – $450 | Reconnecting a disconnected run, patching one tear, resealing one joint |
| Mastic sealing of accessible joints | $350 – $900 | Brushing and applying mastic to supply and return joints you can reach |
| Full-house duct sealing | $700 – $1,500 | Every accessible joint across the supply and return system |
| Duct section replacement | $300 – $800 per run | Removing crushed or torn flex duct and installing new insulated duct |
| Register and boot sealing | $90 – $250 each | Sealing the gap between the duct boot and the floor or wall opening |
| Pre-seal cleaning (Rotobrush/Nikro) | $350 – $700 | Mechanical contact cleaning so sealant bonds to bare duct, not dust |
| Post-seal sanitizing | $250 – $600 | Abatement Technologies or Guardsman treatment for microbial and odor concerns |
What pushes a job toward the top of these ranges is usually access, not the size of the leak. A single disconnected run in an open attic is a short job. The same failure buried behind a finished ceiling or under a low soffit takes longer to reach and protect, and that labor shows up in the estimate. Studio City’s older homes often have original sheet-metal ductwork that has been patched and re-taped over the years, so uncovering the actual leak sometimes means removing a pile of old tape first. Replacing crushed flex duct costs more in materials but resolves air loss that sealer alone won’t fix.
Zip code doesn’t change our pricing across the area, so a job in Studio City costs the same whether you’re near Tujunga Avenue or up near Mulholland Drive. The written estimate accounts for the actual layout, not the address.
What Affects Duct Repair & Sealing Pricing in Studio City
- Attic access and attic heat. Many Studio City homes run ducts through attics that get very hot in summer, which means technicians work in demanding conditions and take extra time to protect the duct and themselves. Tight or partially blocked attic access adds labor. An accessible, walkable attic keeps a job near the low end.
- Number of leaks, not just the size. One obvious leak is quick. Fifteen small leaks scattered across the supply and return system take far longer to find and seal. We check every accessible joint rather than only the one you noticed, because air loss usually comes from several places at once.
- Duct material and condition. Older sheet-metal ductwork with failing tape is common in the area’s mid-century housing stock. Crushed or torn flex duct needs replacement, not just sealing. The material determines whether you’re paying for sealer or new duct.
- Return-side work. Return ducts often get skipped because they’re harder to reach, but a leaking return pulls attic air and dust into the system. Sealing both sides adds cost and does more for airflow and dust than supply-side work alone.
- Whether cleaning happens first. Heavy dust and debris inside the duct prevent sealant from bonding. Professional mechanical cleaning with Rotobrush or Nikro equipment is often the necessary first step, and skipping it wastes the money you spend on sealing.
- Post-seal air quality treatment. If there’s a musty smell or a history of moisture in the system, sanitizing with Abatement Technologies or Guardsman products adds to the job. Not every home needs it, but a leaking duct that drew in attic dust or moisture often does.
One thing that does not raise the price here: this is not a climate where duct sealing fights freeze-thaw or winter condensation inside the duct. Studio City’s mild winters mean the main enemy of your ductwork is heat and dust, plus years of tape letting go, rather than cold. That usually makes leak detection more straightforward than it would be in a colder market.
How to Save on Duct Repair & Sealing
The biggest savings come from catching leaks early. A single leaking joint sealed for a few hundred dollars stays a few hundred dollars. Left alone for years, that same leak pulls attic dust and moisture into the system, and you end up paying for cleaning, sealing, and possibly sanitizing all at once. Here’s how to keep the job in the lower part of the range:
- Fix the leak before it fouls the duct. A leak that draws in dust and moisture creates a bigger cleaning bill. If you notice a hot room or a musty smell, get it looked at before another summer passes.
- Seal every accessible joint in one visit. Paying for a return trip to seal what could have been done the first time is the most common avoidable cost. Ask for a whole-system quote against a per-leak quote and compare.
- Combine cleaning and sealing. Sealing a dirty duct wastes money, and cleaning without sealing lets the dust come right back. Doing both in one service visit keeps the total down. This is where our duct repair & sealing work starts: clean, seal, then treat only where needed.
- Get it in writing before work starts. A written estimate protects you from the surprise of a bigger bill after the attic is opened up. We give one free, and it sets the final price.
- Ask about register and boot gaps. Small gaps around floor and wall registers add up to real air loss and are cheap to seal while the technician is already there.
Free estimates are the simplest savings tool of all. Call (855) 658-5111 and we’ll size the job in your Studio City home against these ranges before you decide anything.
FAQs – Duct Repair & Sealing Cost
Is it cheaper to repair and seal ductwork or replace it?
Sealing is cheaper for the vast majority of Studio City homes, usually $350 to $1,200 versus several thousand for a full duct replacement. Replacement only makes financial sense when the duct is crushed, collapsed, or contaminated beyond cleaning across most of the system. A technician checks the condition of the duct before quoting, and we’ll tell you plainly when replacement is the better call. Call (855) 658-5111 for a free estimate and we’ll give you both numbers.
How much does it cost to seal one leaking duct in Studio City?
A single leaking joint or disconnected run in Studio City typically costs $180 to $450 to repair and seal. The price depends mostly on access. A leak you can reach from an open attic is quick; the same leak behind finished ceiling or a low soffit takes longer. We check the surrounding runs while we’re there, because one leak usually signals others. Call (855) 658-5111 for an exact quote, which is free.
Can leaking ducts really raise my energy bill that much?
They can, and it’s usually the first thing a homeowner notices, in the form of a room that won’t cool or a system that runs longer than it should. The fix in Studio City usually falls between $350 and $1,200 for sealing, which is often less than a season or two of wasted cooling. We can’t tell you a specific savings number, but we can show you where the leak is and what it’s doing. Call (855) 658-5111 to schedule a free estimate.
Do I need duct cleaning before sealing?
Yes, in most cases, because sealant won’t stick to a dirty duct. Pre-seal cleaning with Rotobrush or Nikro mechanical contact equipment typically adds $350 to $700 to the job, and skipping it usually means the seal fails early. The cleaning and sealing are part of the same service visit, which is one reason we treat air duct cleaning in Studio City and duct sealing as one continuous job rather than two separate trades. Call (855) 658-5111 and we’ll quote both together.
Can you come today?
Same-day service is often possible depending on the schedule, so it’s worth calling. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside those dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (855) 658-5111 for a free estimate and the soonest available time.
Why Professional Sealing Beats Tape and Consumer Kits
Duct tape is the wrong tool, and it fails in exactly the conditions a Studio City attic provides: heat and time. The adhesive dries out and lets go within a few years, and the leak comes back. Mastic, applied to a clean surface, cures into a permanent seal. That’s why the equipment and the sequence matter as much as the product.
We use Rotobrush and Nikro mechanical contact cleaning systems, the same professional-grade equipment used in commercial duct work, to get the duct clean before sealing. For homes with microbial or odor concerns, we apply Abatement Technologies and Guardsman sanitizing agents after mechanical cleaning. For homeowners who want better filtration and long-term air quality, we install and service Honeywell and Aprilaire systems, which pick up where cleaning and sealing leave off. Our technicians have up to 10 years of experience matching the right approach to the specific system in front of them, and the local pro we connect you with is licensed and insured as their state requires.
Please leave the work to a trained technician. Attic ductwork involves sharp sheet-metal edges, tight spaces, and high temperatures, and a poorly handled repair can crush the duct or leave a worse leak than the one you started with. Our job is to preserve the air pathway, not damage it.
What the Estimate Covers
When you call, we walk the system, find the leaks, and quote each part of the job against the ranges on this page. You get a written estimate that sets the final price, plus a clear explanation of what’s being sealed, what’s being replaced, and whether cleaning or sanitizing is needed. There’s no charge for the estimate, and no work begins until you say so.
If you’re a property manager handling several units, we scope each one separately and put the total in writing, so you can plan against the numbers rather than a vague range. The local professionals we connect you with are licensed and insured as their state requires, and the estimate reflects the actual layout of each unit, not a flat per-door guess.
When to Call for Duct Repair & Sealing in Studio City
Call when a room won’t heat or cool like the rest of the house, when dust settles faster than it used to, when you smell something musty at the vents, or when you can’t remember the last time the ducts were checked. Any one of those is reason enough to have the system looked at, and the sooner the leak is sealed, the less you spend. Sealing sits alongside the rest of our full air pathway service, including dryer vent cleaning and HVAC cleaning, so the whole system gets attention in one visit rather than piecemeal.
We also help with the air quality side once the ductwork is sealed: air quality & sanitizing treatments and Sherman Oaks duct cleaning for neighbors just across the hill. Whether the job is a single leak or a whole-house seal, the process is the same: clean it, seal it, treat it.
Studio City homes tend to have ductwork that’s been patched and re-patched, and the result is a system losing air in a dozen small places. Sealing it properly brings the airflow back where you want it and stops paying to cool the attic. We give free estimates against transparent ranges, we put the price in writing before work starts, and we don’t leave an underlying leak in place after a cleaning. Call (855) 658-5111. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Studio City market as of 2026. Air Duct Cleaning Studio City offers free estimates – call (855) 658-5111.
Written by the team at Air Duct Cleaning Studio City.
What Our Customers Say
"My wife's allergies had been bad in this house since we moved in. It's been two months since they did the ducts and it's noticeably better. Not a miracle, but real."
- Gilbert Herrera"Job was done well and the house smells better. There was some dust knocked loose around a couple of the registers that I had to wipe down afterward."
- Brooke Novak"Two guys, about three hours, plastic down at every register, and they wiped the vent covers before putting them back."
- Gabriela Torres